Process Design

NOx Emission Control

SO2/HCl Emission Control

Mercury, Dioxin and Furan Emission Control

CO Emission Control

Cadmium, Lead, and PM Emission Control

Decreasing Auxiliary Fuel Consumption

Combustion Diagrams

Optimizing Burning Capacity

US EPA MACT LLLL/MMMM Emission Compliance

Olivine or Silica Sand Selection

PFD & P&ID Development

Equipment Sizing

Heat and Mass Balances

Chemical Consumption and Performance Guarantees

Waste Heat Recovery with Heat Exchangers, Boilers, and Organic Rankine Cycle

Lagoon Sizing

Developing Equipment Specifications

Troubleshooting

Clinkers and Scaling

Hot Spots

Acid Gas Condensation and Corrosion

Oxygen Analyzer Problems

Tuyere Failures

Excessive Scrubber Pressure Drop

Sand Sifting Into Windbox

Fixed Carbon Bed Mercury Removal System Operational Problems

Stack Testing

MACT LLLL/MMMM Stack Testing

Sludge, Ash Slurry, Effluent Water Analysis

MACT LLLL/MMMM Monitoring Parameters

Training

MACT LLLL/MMM Process Training

(On-Line Training Only)